The device I am trying to connect in the same way is a Joowin Outdoor High Power Wireless AP / Wifi Range Extender (model JW-EW74).Īfter completing the bridge mode setup on the Joowin device, I connected it by ethernet cable to my Airport Extreme, but now when I connect to the internet, the signal drops out intermittently, and the Joowin extender never appears in AirPort Utility (or does that only show Apple devices?) The Airport Extreme is connected to a modem, and is already being extended by an AirPort Express in bridge mode without any issues. I understand this cannot be done wirelessly due to Apple's proprietary design, but I am using an ethernet cable and trying to connect a non-Apple range extender in bridge mode. How to Configure TP-Link N router as a wireless Access Point? | TP-LinkĬan you set up a non-Apple WiFi range extender to work in bridge mode with an Airport Extreme? Maybe I used the wrong search terms, but for the life of me, I could not find any discussion here about adding an ethernet-connected, non-Apple WiFi extender to an Airport Extreme. Probably best to get with TP Link Support.Ī quick 30 second search produced this article on how to configure the TP Link as a Wireless Access Point. Look for information about how to set up the TP Link device as a Wireless Access Point (WAP). Not sure that we will be able to provide much help with a TP Link product on a support forum for Apple products. I haven't found definitive instructions via TP Support. The "wizard" takes care of everything else automatically. All that you really need to do is assign a device name to the new AirPort. If you had another AirPort Extreme, or any other AirPort router, the set up "wizard" in AirPort Utility would have set things up correctly in about 60 seconds. In addition, the TP-Link must be set up in Bridge Mode to work correctly with the AirPort Extreme. That means that it will create a wireless network that uses the exact same wireless network name, same wireless security and same password as the AirPort Extreme network. You would set up the TP-Link was a Wireless Access Point (WAP). Otherwise, since it has an ethernet port, my instinct is If the TP-Link device will connect back to the AirPort Extreme using a permanent wired Ethernet cable connection, then the speeds on the network should be maintained. If the TP-Link will wirelessly extend the signal, then it is typical for extenders to reduce the maximum potential speed on the network by half or more. To configure it if that is the best route to take. Would not degrade the networks overall signal. Having it join the network, but i'd think connecting it via ethernet to the Extreme I can see where it might be 'plug and play' if simply plugging this device in and This is not quite as simpleĪs I'd hoped and I haven't found definitive instructions via TP Support info. Network on a remote wifi computer, or does the device 'integrate' or mesh into theĮxisting wifi network originating from the Extreme. This way but does this mean a user would need to select a separate TP-Link I do? Does it act like a repeater? I am trying to figure out how to set it up To place it at the distant location outlet, and hardwire it to one of the E-net Range extender to try and am fairly lost on the best way to configure it.įirst off, if using one of these can diminish overall ISP speeds I don't want Work computers are ethernet-connected but I got a TP-Link AC1750 Airport Extreme is the base station in my office. I'd like to improve wifi coverage on the other end of a building. Hoping you guys can give me a simple breakdown on how to do this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |